Conventional Hydraulic Press Brake (PPT100/30)

For conventional PPT series press brake, we have the following models.
PPT40/12.5 (pressing force 400KN, bending length 1250mm)
PPT40/20 (pressing force 400KN, bending length 2000mm)
PPT40/25 (pressing force 400KN, bending length 2500mm)
PPT50/20 (pressing force 500KN, bending length 2000mm)
PPT70/25 (pressing force 700KN, bending length 2500mm)
PPT70/30 (pressing force 700KN, bending length 3050mm)
PPT100/25 (pressing force 1000KN, bending length 2500mm)
PPT100/30 (pressing force 1000KN, bending length 3050mm)
PPT100/40 (pressing force 1000KN, bending length 4000mm)
PPT135/30 (pressing force 1350KN, bending length 3050mm)
PPT135/40 (pressing force 1350KN, bending length 4000mm)
PPT135/60 (pressing force 1350KN, bending length 6000mm)
PPT165/30 (pressing force 1650KN, bending length 3050mm)
PPT165/40 (pressing force 1650KN, bending length 4000mm)
PPT165/60 (pressing force 1650KN, bending length 6000mm)
PPT200/30 (pressing force 2000KN, bending length 3050mm)
PPT200/40 (pressing force 2000KN, bending length 4000mm)

Featuring:
Made under technology license from LVD, Belgium.
Synchronization achieved through torsion bar.
With REXROTH/BOSCH hydraulic system from Germany.
With TELEMECANIQUE/SCHNEIDER electrical components.
With NACHI pump from Japan.
With MERKEL/NOK oil seals.
With overload protection reliability.

Standard of equipment on the press brake:
Manual adjustment back gauge. (motorized or NC is option)
Manual adjustment bending depth. (motorized or NC is option)
Manual adjustable crowning on table.
Working table with T-slot on both front and back side.
With two front supporting arm mounting on the table.
Control panel on electrical cabinet.
Double foot switch with emergency stop button.
One copy of operation and maintenance manual in English.

One set of straight up tool and multi Vee die block
(European type / AMADA type/ American type punch is available)
Single V die, Sectional V die, 2-V die and multi-Vee block is availabe.